This is a 4 port Renesis engine that was built to power a rock crawler for Campbell Enterprises. These pictures show the engine during initial buildup, and dyno testing, and finally at Campbell Enterprises while the chassis is being built. We will post more pictures once the vehicle is completed.

The engine is mildly ported, and utilizes the stock intake manifold, a TWM billet throttle body, and a small extension for the K&N filter, and air temp sensor.

The stock fuel injectors and ignition coils are controlled by a Motec M4 engine management system, which is triggered by our bolt on 36-2 Renesis trigger wheel, and the stock pickup.

The dyno testing was done with our adjustable length Renesis test headers. A set of custom headers will be fabricated to fit the vehicle.